Sterling 882.01749.00 Manuel D’Utilisation

882.01749.00  

74 

of 

93 

 

 

 

1.  Switch the control unit “Off” with the “On/Off” switch. 

  2.  Disconnect the power supply. 

3.  Empty the dosing station. 

4.  Open the toggle latches on the dosing    

      motor. 

5.  Remove the dosing unit from the 

     dosing motor. 

6.  Open the profile clamp (C) of the dosing 

container. 

7.  Remove the profile clamp (C). 

8.  Remove the dosing module 

     (A and B). 

9.  Loosen the 3 plastic screws on 

     the wiper. 

10. Remove the wiper and holding plate. 

11. Install the new wiper along with  the holding plate. 

12. Tighten down the 3 plastic screws. Make sure that the wiper is fitted parallel to  

the dosing plate (Use only plastic screws to avoid damage to the extruder or 

13. Install the dosing hopper on the dosing housing, ensuring the guide pin is in place, 

      and locate the “shelf” above the module discharge hole. 

14. Install and tighten the profile clamp.