Ricoh MP 2500 Manuel D’Utilisation
When a Message Is Displayed
43
4
Alert Messages
This section describes the machine alert messages.
Message
Cause
Solution
Problem:Wire-
less card
An error may have occurred in
the IEEE 802.11b card.
the IEEE 802.11b card.
Turn off the main power switch,
and back on again. If the message
appears again, contact your sales
or service representative.
and back on again. If the message
appears again, contact your sales
or service representative.
Problem:Wire-
less board
An error may have occurred in
the IEEE 802.11b board.
the IEEE 802.11b board.
Turn off the main power switch,
and back on again. If the message
appears again, contact your sales
or service representative.
and back on again. If the message
appears again, contact your sales
or service representative.
Reset Paper Tray
correctly.
The selected paper tray does not
exist or is not set correctly.
exist or is not set correctly.
Set the paper tray correctly.
DToner is al-
most empty. Add
most empty. Add
toner.
Toner is running out.
Replace the toner cartridge soon
to maintain print quality.
to maintain print quality.
Paper Tray is in
use.
The specified paper tray is in use
by another function, such as the
copier function.
by another function, such as the
copier function.
Wait until the other function has
finished using the specified paper
tray.
finished using the specified paper
tray.
Tray # Error
An error has occurred with the
paper tray.
paper tray.
# indicates the tray number.
Press [JobReset] to change the pa-
per tray settings, or press [Form-
Feed]
per tray settings, or press [Form-
Feed]
to select another paper tray
and print using that.
USB has a prob-
lem.
An error has occurred in the USB
interface.
interface.
Turn off the main power switch,
and back on again. If the message
appears again, contact your sales
or service representative.
and back on again. If the message
appears again, contact your sales
or service representative.
Duplex mode is
in off position
for Tray #
The selected paper tray has not been
configured for duplex printing.
configured for duplex printing.
# indicates the tray number.
Press [JobReset] to change the pa-
per tray settings or do single- sid-
ed printing.
per tray settings or do single- sid-
ed printing.
For details about the tray settings,
see “Tray Paper Settings”, Gener-
al Settings Guide.
see “Tray Paper Settings”, Gener-
al Settings Guide.
Ethernet Board
Error
An error has occurred in the
Ethernet board.
Ethernet board.
Turn off the main power switch,
and back on again. If the message
appears again, contact your sales
or service representative.
and back on again. If the message
appears again, contact your sales
or service representative.
NV-RAM Error
An error has occurred in the machine. Turn off the main power switch,
and back on again. If the message
appears again, call your sales or
service representative.
appears again, call your sales or
service representative.
[Print] without
below mode?
This is an alert message concern-
ing a paper tray in auto tray select.
ing a paper tray in auto tray select.
Press [Print] to cancel the mode
and print the job.
and print the job.