Sharp AL2041 Manuel D’Utilisation
7
7
64
This chapter describes the special functions of this unit. Use these functions as
needed.
needed.
DESCRIPTION OF SPECIAL FUNCTIONS
Toner save mode
Reduces toner consumption by approximately 10%.
Power save modes
The unit has two power save modes of operation: preheat mode and auto power
shut-off mode.
shut-off mode.
Preheat mode
When the unit enters the preheat mode, the power save (
) indicator will light up
and other indicators will remain on or off as before. In this condition, the fuser in
the unit is maintained at a lower heat level, thereby saving power. To copy from
the preheat mode, make desired copier selections and press the start (
the unit is maintained at a lower heat level, thereby saving power. To copy from
the preheat mode, make desired copier selections and press the start (
) key
using the normal copying procedure.
Auto power shut-off mode
When the unit enters the auto power shut-off mode, the power save (
) indicator
will light up and other indicators will go out. The auto power shut-off mode saves
more power than the preheat mode but requires a longer time before starting
copying. To copy from the auto power shut-off mode, press the start (
more power than the preheat mode but requires a longer time before starting
copying. To copy from the auto power shut-off mode, press the start (
) key.
Then make desired copier selections and press the start (
) key using the
normal copying procedure.
Auto clear
The unit returns to the initial settings a preset amount of time after the end of job.
This preset amount of time (auto clear time) can be changed.
This preset amount of time (auto clear time) can be changed.
Resolution of AUTO & MANUAL mode
You can set the copy resolution used for AUTO and MANUAL (
) exposure
mode.
Prevention of OC copies when the original cover/SPF is up function
When enabled, this function may help prevent wasteful use of toner that occurs
when the original cover/SPF is not completely closed.
If the start (
when the original cover/SPF is not completely closed.
If the start (
) key is pressed when the original cover/SPF is not completely closed,
"
" will appear in the display and copying may not take place. If copying does not
take place, copying can be performed by pressing the start (
) key again, however,
the scan size set in "Copy effective paper width setting function" (program numbers
25, 26) will be used.
If the original cover/SPF is completely closed after "
25, 26) will be used.
If the original cover/SPF is completely closed after "
" appears, copying will take
place at the normal size.
SPECIAL FUNCTIONS