OKI OL610E Manuel D’Utilisation

                                                                                                                                                
3. PARTS REPLACEMENT
This section covers the procedures for the disassembly, reassembly and installations in the field. This 
section describes the disassembly procedures, and for reassembly procedures, basically proceed with 
the disassembly procedures in the reverse order.
3.1 Precautions Concerning Parts Replacement Note: Always use good anti-static methods. (1) Parts 
replacements must be carried out, by first turning the printer power switch off [O] and removing the 
Multi-Purpose Feeder from the printer. (2) Do not disassemble the Multi-Purpose Feeder if it is operating 
normally. (3) Establish the extent of disassembly suitable for the purpose of the procedure, and do not 
disassemble any more than necessary. (4) Use only specified service tools. (5) Disassembly must be 
carried out according to the prescribed procedures. Parts may be damaged if such procedures are not 
followed. (6) Small parts such as screws and collars can easily be lost, therefore these parts should be 
temporarily fixed in the original location. (7) When handling printed circuit boards, do not use gloves, 
which may generate static electricity.
(8) Do not place the printed circuit boards directly on the equipment or floor.
[Service Tools]
Table 3-1 shows the tools required for the replacement of printed circuit boards and units in the field.
Table 3-1 Service Tools

OKI OL600/610ex (96-01-18