Xerox 5230A Manuel D’Utilisation
Fault Codes
427
116-720
A print error occurred due to insufficient memory. Close unused ports or delete
unnecessary data.
unnecessary data.
116-740
A print error occurred. A parameter value is greater than the limit value. Check
the print settings.
the print settings.
116-749
The print job was stopped, because the specified font was not found. Install the
font, or enable the font substitution setting in the print driver.
font, or enable the font substitution setting in the print driver.
116-752
The description in the PDF print job ticket has a problem. Repeat the same
procedure. Contact the Xerox Welcome Center if the problem persists.
procedure. Contact the Xerox Welcome Center if the problem persists.
116-771
116-772
116-773
116-774
116-775
116-776
116-777
116-778
116-772
116-773
116-774
116-775
116-776
116-777
116-778
The parameter values were corrected, because the machine encountered a
problem when printing the data. If the received image is incomplete or
damaged, ask the sender to check the image and to resend the data. When
Internet Fax forwarding is enabled, check with the recipient if the image has no
problem.
problem when printing the data. If the received image is incomplete or
damaged, ask the sender to check the image and to resend the data. When
Internet Fax forwarding is enabled, check with the recipient if the image has no
problem.
116-780
The document attached to the received e-mail has a problem. Check the
attached document.
attached document.
116-790
• If the machine did not staple any print sets, check that the specified stapling
position is appropriate, and then try again.
• If a user stops a confidential Fax or Internet Fax print job while the machine is
printing the data of the job, the machine will not staple the first print set.
Manually staple the first set in that case.
Manually staple the first set in that case.
123-400
The machine has detected a software-related problem. Switch off the machine,
and then switch it on again. Contact the Xerox Welcome Center if the problem
persists.
and then switch it on again. Contact the Xerox Welcome Center if the problem
persists.
124-328
A punch unit was not found. Specify a punch unit following the screen
instructions.
instructions.
124-701
Due to a malfunction in the specified tray (left side tray), the output destination
was changed to the center tray. Contact the Xerox Welcome Center. The other
trays are available.
was changed to the center tray. Contact the Xerox Welcome Center. The other
trays are available.
124-702
Due to a malfunction in the specified tray (finisher tray), the output destination
was changed to the center tray. Contact the Xerox Welcome Center. The other
trays are available.
was changed to the center tray. Contact the Xerox Welcome Center. The other
trays are available.
124-705
The punch setting was cancelled.
Check the punch position, and try again.
Check the punch position, and try again.
124-706
The folding setting was cancelled.
Check the folding setting, and try again.
Check the folding setting, and try again.
124-708
The output destination was changed to the center tray. Check if the specified
size paper is loaded in a paper tray.
size paper is loaded in a paper tray.
124-709
The document exceeded the maximum number of pages that can be stapled.
Reduce the number of pages, or cancel the stapling setting, then try printing
again.
Reduce the number of pages, or cancel the stapling setting, then try printing
again.
Code
Description and Remedy