Toshiba 5520c Manuel D’Utilisation

 

e-STUDIO5520C/6520C/6530C 

© 2008 TOSHIBA TEC CORPORATION All rights reserved 

2-26 

 
* You can start with any of the procedures.  But it is recommended to perform the procedures in order, as listed 

below.  You can use one procedure in conjunction with another.  But if this changes the image quality more 
than required or loses the effectiveness of the adjustment, restore the settings made in the previously used 
procedure to the original ones.  Then use other procedures. 

* Both the service technician and the user can use procedure (1). 
* Only the service technician must use procedures (2) to (4). 

 

(1)  Press the [IMAGE] button on the Control Panel.  Press the [BACKGROUND ADJUSTMENT] button. 

Press the [LIGHT] button to decrease the background density. 

 
 

After decreasing the background density, copy and check the image quality. 

 

With the background density set to the minimum, if further image quality adjustments are still necessary, the 

service technician must use the next procedure. 

 

(2)  Enter adjustment mode [05]. Change the values for codes [7033], [7034], [7041] to [7044], [7048] and 

[7049] to adjust the density level of the background. 

Text/Photo 05-7041 

Text 05-7042 

Photo 05-7048 

Manual density 

adjustment 

Image smoothing 

05-7049 

Text/Photo 05-7033 

Text 05-7034 

Photo 05-7043 

Manual adjustment

Image smoothing 

05-7044 

Set a value smaller 

than 128.  

0 to 
255 

128 

*  Set the value in increments of approximately 25, while checking the copy image until the optimum value is 

obtained. 

 

 

After adjusting the background density, copy and check the copy image quality. 

 

If further image quality adjustments are still necessary, use the next procedure. 

 

(3)  Enter adjustment mode [05]. Change the values for codes [590] to [592] to adjust the gamma balance in 

each of low- and medium-density areas. 

Text/Photo 05-590  0/1 

Text 05-591 

0/1 

Photo

 

05-592 0/1 

Set a value smaller than 128.

0 to 255 

128 

*  Set the value in increments of approximately 20, while checking the copy image until the optimum value is obtained.