Toshiba 165/205 Manuel D’Utilisation

Installing the USB Driver    17

Never turn the power off of the equipment or pull out the USB cable while you are installing the 
e-STUDIO163/203/165/205 software and data communication is being performed between the 
equipment and your PC.

When using the e-STUDIO163/203/165/205 is connected to your PC via the USB cable and 
powered on Windows will prompt to install drivers for the new hardware. 
Drivers are provided on the CD in the "Driv_USB" folder, select to install drivers from this spe-
cific location.

These drivers will install an additional COM port, in Windows through which the Toshiba Viewer 
will then communicate with the e-STUDIO163/203/165/205. There are various ways of installa-
tion according to the Windows version running on your PC.

The following describes an installation on Windows 98 Second Edition.
The procedure is almost the same when Windows Me is used.

Make sure you understand the following information.
An additional COM port can only be installed on your PC by your executing USB driver installa-
tion two times. Even if you finish the installation by clicking the [Finish] button on the “Add New 
Hardware Wizard”, the communication port will not be installed. When the “Add New Hardware 
Wizard” appears again after clicking the [Finish] button, follow the procedure in the manual to 
execute the USB driver installation once again.