DELL C3765dnf Mode D'Emploi

Understanding the Printer Menus

IP Filter feature is available only for 

LPD

 or 

Port9100

.

Purpose:
To block data received from certain IP addresses through the wired or wireless network. You can set up to five IP 

addresses. The change becomes effective after the printer is turned off and then on again.
Values:

IEEE 802.1x feature is available only when the printer is connected using Ethernet cable and it is available only when the 

IEEE 802.1x authentication is enabled.

Purpose:
To disable IEEE 802.1x authentication. The change becomes effective after the printer is turned off and then on 

again.

Purpose:
To specify PostScript communication protocol for a parallel interface, you can configure the Adobe Protocol 

settings for the wired network. The change becomes effective after the printer is turned off and then on again.
Values:

Purpose:
To initialize wired network data stored in non-volatile memory (NVM). After executing this function and rebooting 

the printer, all wired network settings are reset to their default values.

Use the Fax Settings menu to configure the basic fax settings. 

Values marked by an asterisk (*) are the factory default menu settings.

Purpose:
To configure basic settings for the fax line.

Sets the IP address for Filter n.

Sets the address mask for Filter n.

Disables the IP Filter feature for Filter n.

Accepts an access from the specified IP address.

Rejects an access from the specified IP address.

Used when auto-detecting the PostScript communication protocol.

Used when the communication protocol is in ASCII interface.

Used when the communication protocol is in binary format.

Used when the communication protocol supports both ASCII and binary data to switch 

between them according to the specified control code.

Used when no special processing is required for data.