Sharp PN-LB02B Manuel D’Utilisation

50

E

You can configure settings related to SNMP.

SNMP SETTING
Set whether to enable or disable SNMP.
VERSION
Set the version of the SNMP to be supported.
COMMUNITY NAME 1 to 3
Set the name of the community required for the access.
USER 1 to 3
Set the user name, password, authentication method and 

other options required for access.
TRAP SETTING
Set whether to enable or disable the trap function.

When this function is enabled, a trap will be sent when the

monitor is turned on.
TRAP SETTING OF AUTHENTICATION ERROR
Set whether the trap function sends a notification when

authentication fails.
TRAP ADDRESS & PORT
Set the destination address and port number of the 

notification sent by the trap function.

Caution

•  After you set SNMP, click [Switch the main power of

monitor off and on now.] or turn off the monitor and then

turn it on again with the main power switch. When the

monitor restarts, wait about 30 seconds and then start the

next operation.

•  If the IP address is changed while the SNMP function is

operational, turn off the monitor and then turn it on again 

with the main power switch.

TIPS

•  Depending on the SNMP settings, a short delay may occur

before the SNMP is usable. (About 2 minutes)

•  Up to 16 alphanumeric letters and symbols can be used for

the community name, user name and password.

You can display a specific URL in the URL INFORMATION

field on the INFORMATION screen when an error occurs in

the monitor. (See page 46.)

URL INFORMATION
Enter the URL to display on the INFORMATION screen when

an error occurs on the monitor.

Up to 64 alphanumeric characters or symbols can be used.
CONDITION
Specify the condition to display the URL.
CONFIRMATION
The home page of the specified URL is displayed.

You can check whether the URL you entered is correct.

TIPS

•  It is also possible to specify the message text, such as the

name of a contact or a telephone number, to be displayed 

instead of the linked URL.