Runco PL-61CX Manuel D’Utilisation
1
You can attach your optional mounts or stand to the plasma
monitor in one of the following two ways:
1) While it is upright. (See drawing A)
2) As it is laid down with the screen face down (See
drawing B). Lay the protective sheet, which was wrapped
around the plasma monitor when it was packaged, beneath
the screen surface so it does not scratch the screen face.
* DO NOT touch or hold the screen face when carrying
the unit.
• This device cannot be installed on its own. Be
sure to use a stand or original mounting unit.
(Wall mount unit, stand, etc.)
• For correct installation and mounting it is
required to use a trained, Runco Authorized Dealer.
Failure to follow correct mounting procedures
could result in damage to the equipment or injury
to the installer. Product warranty does not cover
damage caused by improper installation.
Use only the mounting kit or stand provided by
maufacturer and listed under options.
Drawing B
Drawing A
Ventilation Requirements for enclosure mounting
To allow heat to dispearse, leave space between
surrounding objects as shown on the diagram to the
right when installing.
50
mm
(2")
50
mm
(2")
50
mm
(2")
Wall
Wall
50
mm
(2")
50
mm
(2")
How to use the safety metal fittings and the screws
for safety metal fittings
These are fittings for fastening the unit to a wall to
prevent tipping due to external shock when using the
stand (optional). Fasten the safety fittings to the holes
in the back of the monitor using the safety fitting
mount screws.
* Safety metal fittings will differ according to the
model.
Wall
Table Top
Safty metal fittings
Metal chain
(Not supplied)
Screw for Safety
metal fittings
Screw hole
Screw or Hook etc.
(Not supplied)
How to Attach Options to the Plasma Monitor