Seagate ST39102LW/LC Manuel D’Utilisation
46
Cheetah 9LP Installation Guide, Rev. B
LC drives
LC drives section
Setting the SCSI ID jumpers
The SCSI ID is normally set over the SCSI bus by the host sys-
tem. You can also use the J6 jumper block to set the SCSI ID
(Figure 16). To change the SCSI ID, install jumpers as shown in
the illustration.
tem. You can also use the J6 jumper block to set the SCSI ID
(Figure 16). To change the SCSI ID, install jumpers as shown in
the illustration.
Figure 16. Setting the SCSI ID on LC drives
SCSI ID = 0
(default)
Note:
[1] Do not remove
cover from pins
13 through 20
(darkened area).
cover from pins
13 through 20
(darkened area).
Jumper Plug
(enlarged to
show detail)
show detail)
J6
Drive
Front
Front
Pin 1
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
SCSI ID = 8
SCSI ID = 9
SCSI ID = 10
SCSI ID = 11
SCSI ID = 12
SCSI ID = 13
SCSI ID = 14
SCSI ID = 15