DELL 2385P Manuel D’Utilisation

Setup Wizard Basic Configuration of the Filer3-5

4. From a client attached to the network, point your browser to the filer address

given; the Setup Wizard loads.

5. Enter the information as requested.

:KHUHWR*R)URP+HUH

Verify the network connections of your new filer using the procedure in "Verifying Net-

work Connections."

9HULI\LQJ1HWZRUN&RQQHFWLRQV

'HVFULSWLRQ

After you configure the filer, you use the

ping

command from a client attached to the

network to verify that the filer is set up correctly and can communicate with other

computers on the network.

6WHSV

To verify filer communication, perform the following steps:

At a client attached to the network, enter the following command:

SLQJILOHULSDGGUHVV!

2. Replace

with the Internet protocol (IP) address that you

assigned the filer.

3. Repeat the test for each interface that is installed in the filer.

([DPSOHV

The following examples test the network connections for a filer that has the host

name filer with two interfaces named e0 and f0 installed:

SLQJILOHUH

SLQJILOHUI

7URXEOHVKRRWLQJ

If an interface does not respond to a

ping

command, make sure that:

The interface is securely attached to the network.

The media type is set up correctly if the interface is on an Ethernet card contain-

ing different media connectors.

The routers function properly with correct routing information if the

ping

com-

mand is issued from a network not directly attached to the interface.