FieldServer FS-8700-66 Manuel D’Utilisation
Page 11 of 29FS-8700-66_GE-SNP Manual
Page 11 of 29
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com
Tel: (408) 262-2299 Fax: (408) 262-2296 Toll_Free: 888-509-1970 email: support@fieldServer.com
4.4.2.
Driver Related Map Descriptor Parameters
Column
Title
Function
Legal Values
Node_Name Name of Node to fetch data from
One
of
the
Node
names
specified
in
“Client
Node
Descriptor” above
Data_Type
Data type
Discrete Inputs (%I)
Discrete Outputs (%Q)
Discrete Temporaries
(%T)
Discrete
Discrete Outputs (%Q)
Discrete Temporaries
(%T)
Discrete
Internals
(%M)
Genius Global Data
(%G)
Analog Inputs (%AI)
Analog
Genius Global Data
(%G)
Analog Inputs (%AI)
Analog
Outputs
(%AQ)
Registers (%R)
%SA Discrete
%SB Discrete
%SC Discrete
%S Discrete (%S)
Registers (%R)
%SA Discrete
%SB Discrete
%SC Discrete
%S Discrete (%S)
Length
Length of Map Descriptor. Ensure that the
length does not exceed the table in the PLC
length does not exceed the table in the PLC
1-1000
Address
Starting address of read block / write block. The
1
1
st
element of each Data type Table is referred
to as address one.
1 , 2 , 3
Positive
Positive
whole
numbers
Format*
Use to override the default format for obtaining
data. Bit tables are by default read by reading
whole bytes at a time (If the Length is 10 then
10 bytes of data are read and placed in 10 Data
Array locations)
If you wish to read bits instead then use this
parameter. (If the Length is 10 then 10 bits are
read and each bit is stored in its own location.)
data. Bit tables are by default read by reading
whole bytes at a time (If the Length is 10 then
10 bytes of data are read and placed in 10 Data
Array locations)
If you wish to read bits instead then use this
parameter. (If the Length is 10 then 10 bits are
read and each bit is stored in its own location.)
Bit, Byte
The format for %AI,
%AQ and %R cannot
be changed.
The format for %AI,
%AQ and %R cannot
be changed.
GE_Func*
This parameter is only specified when you
create a write Map Descriptor to change the
privilege level.
If it is not specified the driver assumes the
default (RW – Read/Write).
create a write Map Descriptor to change the
privilege level.
If it is not specified the driver assumes the
default (RW – Read/Write).
CPL, RW
4.4.3.
Timing Parameters
Column Title
Function
Legal Values
Scan_Interval
Rate at which data is polled
≥0.1s