Fujitsu MAX3073RC Manuel D’Utilisation

 

C141-E237 

GL-1 

This is a 1-byte code displayed in the sense data and is information which 
specifies the type of error that was detected. 

Common Command Set 
This is the standard form of SCSI logical specifications stipulated by the 
operations subcommittee of the American National Standards Institute (ANSI) 
which stipulates functions which a direct access device (magnetic disk, etc.) 
should support. 

Command Descriptor Block   
A series of data which describes commands related to input/output operations, 
sent from the initiator to the target. 

This is a command to a target to perform an input/output operation, and it is 
described as the CDB. 

This is an SAS device which initiates input and output operations on the SAS bus.  
In this manual, initiator has been abbreviated to "INIT." 

The general name given to a device which is connected to the SAS bus 
(input/output device, I/O controller, host adapter, expander, etc.). 

Small Computer System Interface 
The standardized input/output interface of the American National Standards 
Institute (ANSI).  [Standard No.:  ANSI X3. 131-1986] 

When several items of error information are included in a command's completion 
status, this is information generated by the target for reporting detailed 
information on that status. 

This is a 4-bit code displayed in the sense data.  It contains information for 
classifying the type of error that was detected. 

This is 1 byte of information reported to the initiator by the target device when 
execution of each command is completed, which displays the command's 
completion state.