Fujitsu MBB2147RC Manuel D’Utilisation
4.3 Connection Requirements
4.3.3
Ready LED output signal
Figure 4.11 shows a recommended circuit for external LED connection to Ready LED output
signal.
signal.
Figure 4.11 Recommended external circuit for Ready LED output
Either +3.3 V or +5 V can be used for external power supply for LED (Vcc). Current limiting
resister (R) value need to be adjusted depend on the Vcc voltage. For +3.3 V Vcc voltage,
recommended resistance is 220
resister (R) value need to be adjusted depend on the Vcc voltage. For +3.3 V Vcc voltage,
recommended resistance is 220
Ω
. For +5 V Vcc voltage, recommended resistance is 330
Ω
.
4.3.4 Connector
requirements
Table 4.3 lists the recommended connectors for the host system.
Table 4.3 Recommended connectors
Manufacture Part
number Remarks
1735104-1
Hybrid (SMT/Dip) type
1735105-1 SMT
type
1735164-1
Press Fit Type
Tyco Electronics AMP
1735234-1
Press Fit Type
SAS-RA29-S1AA-FG
Virtical SMT with Tab
SAS-RC29-S1AA-FG
Virtical SMT with Lock pin
Fujikura
SAS-RC29-S1AB-FG
Virtical SMT with Lock pin
C141-E257
51