Fujitsu 1300U2 Manuel D’Utilisation
2
Formatted Capacity of MO Disks
The indicated capacity of MO disks is based on the calculation of 1KB as being equal to 1,000 bytes.
However, when a disk is formatted by your operating system or when you check a disk's properties,
the displayed capacity may be different, as it is calculated on the basis of 1KB being equal to 1,024
bytes.
However, when a disk is formatted by your operating system or when you check a disk's properties,
the displayed capacity may be different, as it is calculated on the basis of 1KB being equal to 1,024
bytes.
Using this Product for Applications with High Safety Levels
This product is designed and manufactured for use in ordinary applications, such as general office,
personal and home use. It is not designed or manufactured for applications that require high levels of
safety.
Do not use this product for applications where high safety levels are needed without first taking
measures to ensure the necessary safety is provided.
Examples of applications where extremely high levels of safety are required are given below. The
failure to ensure such safety levels can lead directly to serious risk of death and/or injury.
Note that FUJITSU LIMITED accepts no responsibility whatsoever for injury or damage occurring as a
result of the use of this product for applications where high safety levels are required.
personal and home use. It is not designed or manufactured for applications that require high levels of
safety.
Do not use this product for applications where high safety levels are needed without first taking
measures to ensure the necessary safety is provided.
Examples of applications where extremely high levels of safety are required are given below. The
failure to ensure such safety levels can lead directly to serious risk of death and/or injury.
Note that FUJITSU LIMITED accepts no responsibility whatsoever for injury or damage occurring as a
result of the use of this product for applications where high safety levels are required.
Nuclear Power Core Control
Aircraft Flight Control
Air Traffic Control
Mass Transportation Operation Control
Life Support
Weapons Firing Control etc.
Aircraft Flight Control
Air Traffic Control
Mass Transportation Operation Control
Life Support
Weapons Firing Control etc.
Applications with
High Safety Levels
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation:
FCC WARNING:
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Laser Label:
CLASS 1 LASER PRODUCT
This product is Class 1 laser product to EN 60825-1.
CLASS 1 LASER PRODUCT
This product is Class 1 laser product to EN 60825-1.