Toshiba W7 Manuel D’Utilisation
W7 ASD Installation and Operation Manual
21
W7 ASD Control
The Control PCBA (P/N 56000) serves as the primary control source for the W7 ASD and receives
input from the
input from the
PCBA
, an Option Card, RS232/RS485 Communications, or the
.
The Control PCBA has been enhanced to support two new functions: Multiple Protocol
Communications and the ability to communicate in either half- or full-duplex modes.
Communications and the ability to communicate in either half- or full-duplex modes.
Using the optional multiple-protocol communications interface: the ASD-NANOCOM, the Control
PCBA may be configured for the type of communications protocol being received and respond
appropriately to the sending device. The ASD-NANOCOM connects to the J4 and J5 connectors
PCBA may be configured for the type of communications protocol being received and respond
appropriately to the sending device. The ASD-NANOCOM connects to the J4 and J5 connectors
(see
). A jumper PCBA (P/N 55365) is required at the J4 connector if not using the ASD-
NANOCOM.
The ASD-NANOCOM must be setup to support the desired communications protocol via Program
⇒
Comm Settings. Consult the ASD-NANOCOM User’s Manual (P/N 10572-1.000-000) for a complete
listing of the setup requirements.
listing of the setup requirements.
Half or Full duplex communications is available when using RS232/RS485 communications. The
jumpers at the JP1 and the JP2 connectors may be moved from one position to the other to facilitate
either half- or full-duplex operation. If no jumpers are used the system will operate in the full duplex
mode.
jumpers at the JP1 and the JP2 connectors may be moved from one position to the other to facilitate
either half- or full-duplex operation. If no jumpers are used the system will operate in the full duplex
mode.
For more information on the W7 ASD communication requirements, please visit
WWW.TIC.TOSHIBA.COM to acquire a copy of the 7-Series Communications User Manual
WWW.TIC.TOSHIBA.COM to acquire a copy of the 7-Series Communications User Manual
(see Literature
⇒
Manuals
⇒
Drives Manuals) and WWW.ICCDESIGNS.COM to acquire a copy of
the ASD-NANOCOM User Manual.
Contact your Toshiba representative if more information is required on the ASD-NANOCOM.
Figure 6. Control Board of the W7 ASD (P/N 56000).
25-pin D-type connector.
Connects to the Control
Terminal Strip PCBA
Connects to the Control
Terminal Strip PCBA
(CN7)
.
RS232/RS485 signal I/O
(
(
CNU1
).
Common Serial (TTL) I/O
(
(
CNU2
).
CNU3
CN2
CNU8
CNU4
JP1 Jumpers — Half-/Full-Duplex selection.
RS232/RS485 signal I/O
(
(
CN3).
ASD-NANOCOM.