Adaptec MAN-FC2002-001 Manuel D’Utilisation

Setting the Enclosure ID

Chapter 3: JBOD Configurations

This Chapter describes the procedure for connecting your

2Gb SANbloc Series JBOD system to a host computer(s).

Detailed information on how to configure and daisy chain

enclosures is also provided along with instructions on how

to set the enclosure ID.

Setting the Enclosure ID

Each of the fourteen disk drive slots of the 2Gb SANbloc

Series has a unique identifier assigned to it. This identifier is

assigned using a combination of the slot number and the

enclosure ID.

The enclosure ID is set using the enclosure ID switch,

located on the rear of the 2Gb SANbloc (see Figure 3-1).

Note: The enclosure ID must be set prior to powering on the
enclosure.

Note: Each enclosure must have a separate ID when daisy
chained together.

Note: 2Gb Amphenol cables must be used if 2Gb operation
is required.

Note: Only QLogic 2300 and 2310 adapters should be used.