Adaptec MAN-FC2002-001 Manuel D’Utilisation
JBOD Configurations
41
JBOD Configurations
There are two JBOD configurations covered in this Instal-
lation Guide:
•
Dual FC Loop mode (including how to daisy chain enclosures)
•
Quad Loop (single enclosure with 4 FCAL loops)
Note: The following examples show the Copper/Copper I/O
Module option for illustration purposes. The configuration
procedures are identical for all I/O Module options.
Module option for illustration purposes. The configuration
procedures are identical for all I/O Module options.
Dual FC Loop
Configuration
Configuration
Note: For dual FC Loop enclosures there must be two LS
modules installed in the enclosure.
modules installed in the enclosure.
This section describes the procedure for connecting a dual
FC Loop configuration to your host computer, and how to
daisy chain these enclosures together.
To connect the dual FC Loop enclosure to the host:
Note: You will need two HBA’s in your host system, or a single
HBA with support for two connections. A hub, switch or two hosts
with HBA may also be used.
HBA with support for two connections. A hub, switch or two hosts
with HBA may also be used.
1
Insert the connector on the first cable, into the top connector on
the first I/O module (see Figure 3-2).
the first I/O module (see Figure 3-2).
2
Insert the other end of this cable into the connector on your
HBA.
HBA.
3
Insert the connector on the second cable, into the top connector
on the second I/O module (see Figure 3-2).
on the second I/O module (see Figure 3-2).
4
Insert the other end of this cable into the connector on your
HBA.
HBA.