Baldor E100 Manuel D’Utilisation
www.supportme.net
Input / Output 5-13
MN1942
5.3 USB communication
5.3.1 USB port
Location USB
Mating connector: USB Type B (downstream) plug
Pin Name
Description
1 VBUS
USB +5V
2 D-
Data-
3 D+
Data+
4 GND
Ground
The USB connector is used to connect the MicroFlex e100 to a PC running Mint WorkBench. The
MicroFlex e100 is a self-powered, USB 1.1 (12Mbps) compatible device. If it is connected to a
slower USB1.0 host PC or hub, communication speed will be limited to the USB1.0 specification
(1.5Mbps). If it is connected to a faster USB2.0 (480Mbps) host PC or hub, communication
speed will remain at the USB1.1 specification of the MicroFlex e100.
MicroFlex e100 is a self-powered, USB 1.1 (12Mbps) compatible device. If it is connected to a
slower USB1.0 host PC or hub, communication speed will be limited to the USB1.0 specification
(1.5Mbps). If it is connected to a faster USB2.0 (480Mbps) host PC or hub, communication
speed will remain at the USB1.1 specification of the MicroFlex e100.
Ideally, the MicroFlex e100 should be connected directly to a USB port on the host PC. If it is
connected to a hub shared by other USB devices, communication could be affected by the
activity of the other devices. A 2m (6.5 ft) standard USB cable is supplied. The maximum
recommended cable length is 5m (16.4 ft).
connected to a hub shared by other USB devices, communication could be affected by the
activity of the other devices. A 2m (6.5 ft) standard USB cable is supplied. The maximum
recommended cable length is 5m (16.4 ft).
1
4
2
3