Emerson MVME2500 Manuel D’Utilisation

MVME2500 Installation and Use (6806800L01H)

71

Only 115200 bps and 9600 bps are supported. The default baud rate on the front panel serial 
is 9600 kbps. 

The MVME2500 utilizes the Exar ST16C554 quad UART (QUART) to provide four additional 
ports to the RTM. These devices feature 16 bytes of transmit and receive first-in first-out (FIFO) 
with selectable receive FIFO trigger levels and data rates of up to 1.5 Mbps. Each UART has a set 
of registers that provide the user with operating status and control. The QUART are 8-bit 
devices connected to the processor through the local bus controller using LBC chipset CS1, 
CS2, CS3 and CS4.

These four serial interfaces are routed to P2 I/O for RTM accessibility. There are a total of five 
serial ports available on the MVME2500. 

The MVME2500 hosts only one PMC/XMC site and accepts either a PMC or an XMC add-on 
card. Only an XMC or a PMC may be populated at any given time as both occupy the same 
physical space on the PCB. Combination PMC/XM cards are not supported by the MVME2500. 
The site provides a rear PMC I/O. 

The PMC site is fully compliant with the following:

1. VITA 39 –PCI-X for PMC

2. VITA 35-2000 for PMC P4 to VME P2 Connection

3. PCI Rev 2.2 for PCI Local Bus Specification.

4. PCI-X PT 2.0 for PCI-X Protocol Addendum to the PCI Local Bus Specs.

5. IEEE Standard P1386-2001 for Standard for Common Mezzanine Card Family

6. IEEE Standard P1386.1-2001 for Standard Physical and Environmental Layer for PCI 

Mezzanine Card.

7. VITA 42 for XMC

8. VITA 42.3 , PCIe for XMC