Fujitsu B23Q8YA-G-02-F Manuel D’Utilisation

 

 

 

   

15 

This chapter describes how to use the secondary LAN (10/100/1000Mbps) port on PRIMEPOWER250/450. 

The secondary LAN port on PRIMEPOWER250/450 is controlled by FUJITSU PCI Gigabit Ethernet 

Driver (Interface name is “fjgi”) included in Solaris 10. 

z  When using 1000 Mbps communication, be sure to set Autonegation to 'on'. 
z  If using the PCI card (PW008GE4/PW008GE5/PW008QG1), please refer to the User’s guide attached 

with the PCI card. 

This section describes required setting to use a fjgi interface. 

This section describes how to edit files required to build environment. 

 

1. 

To use the secondary LAN port as an IPv4 interface: 

To allocate the IP address or hostname to the fjgi interface, edit /etc/hostname.fjgi* (* is an numerical 

value) file. About netmask value, please see "4.3.1.3 Defining Netmask Value" . 

 

Example /etc/hostname.fjgi*: 

Define the unique hostname:   

giga-v4 

or, define the IP address:   

192.168.150.1  

Note: If you defined the hostname in hostname.fjgi* file, see the section "4.3.1.2 Defining Hostname " 

for detailed information. 

 

2. 

To use the secondary LAN port as an IPv6 interface 

To allocate the IP address and prefix to the fjgi interface, edit /etc/hostname6.fjgi* (* is an numerical 

value) file.