Fujitsu B23Q8YA-G-02-F Manuel D’Utilisation

 

 

 

   

29 

z  1:n operation standby mode   
z  Mutual standby mode   
z  TCP/IP communication   
z  Using to the cluster interconnect (PRIMECLUSTER). (But, using in a JumboFrame or as 

VLAN interface can not be performed) 

 

The support ranges of takeover form are the following ranges. 

a. 

PRIMECLUSTER 

Support 

IP Support 

MAC Not 

Supported 

 

(Supported V4.1A10 or later) 

IP+ MAC 

Not Supported   

(Supported V4.1A10 or later) 

 

Using over operation management LAN (LAN used for cluster operation management view) cannot be 

supported. 

Set up the cluster environment in the same way as for the other LAN driver, follow "Setting up the 

Network" in the "PRIMECLUSTER manual". Note that the secondary LAN port (fjgi interface) resource 

name is "fjgi". 

 

Please use "PRIMECLUSTER 4.1 or later" for a cluster system to use fjgi interface. If an earlier version of 

cluster system is used, fjgi interface cannot be used for private LAN nor for IP address fail-over on public 

LAN. 

 

When using fjgi interface as the cluster interconnect, please perform the following command before initial 

composition setup. 

# ifconfig  fjgi*  plumb <Return> 

* is instance-number 

Then, please execute the following command and check that a MTU size of fjgi interface is not 9000byte 

(JumboFrame is not set up). 

# ifconfig  fjgi* <Return> 

* is instance-number 

 

GigabitEthernet in a JumboFrame function cannot be used to the cluster interconnect.   

 

GigabitEthernet as VLAN interface cannot be used to the cluster interconnect.