Aleratec 350117 Manuel D’Utilisation

www.aleratec.com

6

1.  Use the included power adapter and cord to plug the HDD Copy Dock Duplicator 

into a power outlet. 

2.  Insert the SATA Hard Drive you want to copy into the slot marked “SOURCE 

DISK 4”. When inserting, align the SATA port on the Hard Drive with the SATA 

connector in the drive bay slot. Press the “SOURCE DISK 4” power button on the 

front of the unit to power up the drive.

3.  Insert the destination SATA Hard Drives into the slots marked “TARGET DISK 1”, 

“TARGET DISK 2” and “TARGET DISK 3”. When inserting, align the SATA port 

on the Hard Drive with the SATA connector in the drive bay slot. Press the power 

button on the front of the unit to power up the drive target drive(s). 

 

Note: Make sure the target Hard Drive has the same or higher capacity than your 
source Hard Drive. The duplication process will not start if the target drive has 
a lower capacity. Also make sure the unit is not connected to a PC through the 
USB or eSATA ports.

4.  Push the main power button to turn the unit on.

5.  Push the DOWN button to select the Duplicator Mode menu item and press ENT. 

Press ENT two more times to switch to Duplicator Mode.

The system will auto-detect the hard drives. After the drives have been 

detected, a screen similar to the one below will be displayed:

 

 

 

 

 

 

Note: Before copying be sure that the capacity of the target HDD is equal to or 
larger than the source hard drive.