Aleratec 350112 Manuel D’Utilisation

www.aleratec.com

47

Power Requirements

115 - 230 VAC Switchable

Dimensions

(length x width x height)

D: 430mm  W: 190mm H: 355mm   

Weight

9.4 Kilograms

Note: Specifications subject to change without notice. 

If your 1:5 HDD Copy Cruiser IDE/SATA is not performing as expected, refer to the 

symptoms below, and follow the suggested corrective action. 

LCD Display

If the LCD display does not display any message and the 

backlight is not lit after powering on the 1:5 HDD Copy 

Cruiser IDE/SATA, check that the power cable is properly 

connected and that the ON/OFF switch is turned on.

Error Messages

While the system is performing an operation and the 

operation is manually terminated, an error message will 

be shown in the LCD display. This may lead to an failed 

operation and could cause the 1:5 HDD Copy Cruiser IDE/

SATA to stop responding. If this happens, power the unit 

off, wait about ten (10) seconds, and then reapply power.

Hard Disk

If the 1:5 HDD Copy Cruiser IDE/SATA does not detect 

one of the hard disk drives, verify that the drive is properly 

seated in the drive bay.

Keypad Buttons

If pressing the keys on the front panel produces no 

response from the system, the 1:5 HDD Copy Cruiser 

IDE/SATA may still be busy with the previous operation. 

If the system idle, power the unit off, wait about ten (10) 

seconds, and then reapply power.

Firmware Update

The device can be updated to new versions of firmware via 

a DVD/CD drive. If unable to update the firmware, check 

that the firmware was downloaded correctly. A failed 

firmware upgrade may cause the 1:5 HDD Copy Cruiser 

IDE/SATA to become inoperable. If the system is working 

normally, do not attempt this operation. If the system is 

already experiencing problems, please contact Aleratec for 

repairs.

Startup/Shutdown

Do not power off the system while it is performing an 

operation. After a normal shutdown, wait about ten (10) 

seconds before reapplying power.