AMCC 9500S Manuel D’Utilisation

Chapter 2. CLI Syntax Reference

90

/ex/slotx show

This command shows information about the specified /slotx on the specified 
enclosure /ex. The slot name is followed by its status. If a slot has been 
inserted with a drive and no fault has been detected, the status is OK. If the 
slot is empty the status would indicate NO-DEVICE. The port that is 
correlated to the slot is indicated in the next column. If no device is found in 
the slot, that is indicated with a dash (-) in the Port column. The final column 
shows whether “identify” is currently set for the specified slot.

 //localhost> /e0/slot1 show

 Slot      Status          Port          Identify

 ----------------------------------------------------

 slot1     OK              /c0/p1        Yes

/ex/slotx show identify

This command shows the identify status of the specified slot. The status can 
be either on or off.

//localhost> /e0/slot1 show identify

/e0/slot1 Identify status = on

/ex/slotx set identify=on|off

This command causes the slot to be identified by blinking the LED associated 
with it, or turns off identification of the LED for this slot. 

Setting identify to on will cause the LED associated with that slot to blink, 
provided that the EPCT has been set to associate “identify” with “blinking,” 
as is the case in the 3ware Sidecar. 

 This command is equivalent to “/cx/px set identify=on|off” on page 81. 

//localhost> /e0/slot1 set identify=on

Sending Identify request to Drive Slot /e0/slot0 to [on] ... 

Done.