Microsoft G7VP2 Manuel D’Utilisation

Award BIOS Setup Utility

3.1.4 Power Management Setup

The Power Management Setup allows you to configure your system to

most effectively save energy. If you like to use the soft power down

feature of Windows



95/98, you must enable the Power Management

field below. Select Min. Power, Max. Power or User Defined. Either one

can be used as long as it is NOT disabled.

The settings on the screen are for reference only. Your version may not be

identical to this one.

ROM PCI/ISA BIOS

POWER MANAGEMENT SETUP

AWARD SOFTWARE, INC.

Power Management
PM Control by APM
Video Off Method
Video Off After
Standby Mode
Suspend Mode
HDD Power Down
Soft-Off by PWRBTN
Resume on Alarm

: User Define
: Yes
: DPMS
: Suspend
: Disabled
: Disabled
: Disabled
: Instant-Off
: Disabled

ESC
F1
F5
F6
F7

: Quit
: Help
: Old Values
: Load Fail-Safe Settings
: Load Optimal Settings

PU/PD/+/-
(Shift) F2

: Select Item
: Modify
: Color

↑ ↓ → ←

** PM Events **

IRQ3

(COM 2)

IRQ4

(COM 1)

IRQ5

(LPT 2)

IRQ6

(Floppy Disk)

IRQ7

(LPT 1)

IRQ8

(RTC Alarm)

IRQ9

(IRQ2 Redir)

IRQ10 (Reserved)
IRQ11 (Reserved)
IRQ12 (PS/2 Mouse)
IRQ13 (Coprocessor)
IRQ14 (Hard Disk)

IRQ15 (Reserved)

: Primary

: Primary
: Primary
: Primary
: Primary
: Disabled

: Secondary
: Secondary
: Secondary
: Secondary
: Primary

: Primary
: Disabled

sound of the alarm resembles that of the siren of an ambulance.

The failure detection circuit requires a fan to operate at

greater than 3600 RPM.

+3.3V, +5V and +12V Voltages

Set these fields to Monitor if you want the system board to

detect the output voltage of the power supply. If the output

voltage is over or under +3.3V/+5V/+12V (±10%), an alarm

will sound warning you of voltage issue. The sound of the alarm

is continuous low to high beeps but shor ter than the

temperature alarm. Some of the most common causes leading

to unstable output voltage of a power supply are:

- The power supply is not functioning normally. Turn off your

system and replace the power supply.

- The AC input from the power outlet to your system is

unstable. Please consult your MIS department or an

electrician.