Soyo SY-K7ADA V1.0 Manuel D’Utilisation
Hardware Installation
SY-K7ADA V1.0
37
If you set ratio to manual and configure the RJ1 DIP Switch to the settings
that match your CPU speed, as follow table:
RJ1
1
2
3
4
RJ1
1
2
3
4
5
On On Off On
9
On
On
Off Off
5.5
Off On Off On
9.5
Off
On
Off Off
6
On Off Off On
10
On
Off
Off Off
6.5
Off Off Off On
10.5
Off
Off
Off Off
7
On On On Off
11
On
On
On On
7.5
Off On On Off
11.5
Off
On
On On
8
On Off On Off
12
On
Off
On On
8.5
Off Off On Off
12.5
Off
Off
On On
Note: SOYO does not guarantee system stability if the user over
clocks the system. Any malfunctions due to over-clocking are not
covered by the warranty.
clocks the system. Any malfunctions due to over-clocking are not
covered by the warranty.
2-3.3.2 Enable/Disable Power-On by Keyboard (JP1)
You may choose to enable the Power-On through Keyboard function by
shorting pin 2-3 on jumper JP1; or short pin 1-2 to disable this function.
shorting pin 2-3 on jumper JP1; or short pin 1-2 to disable this function.
Power-On by
Keyboard
Enable
Disable
JP1 Setting
Short pin 2-3 to
enable the
Power-On by
Keyboard
function.
Short
pin
1-2
and the
Power-On by
Keyboard
function is
disabled.
Important: When using the Power-On by Keyboard function, please
make sure the ATX power supply is able to provide at least 720mA on
the 5V Standby lead (5VSB) in order to meet the standard ATX
specification.
make sure the ATX power supply is able to provide at least 720mA on
the 5V Standby lead (5VSB) in order to meet the standard ATX
specification.
1 2 3
1 2 3