Black Box VSC-VPLEX4 Manuel D’Utilisation
724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 13
Chapter 2: Overview
Fitting the VideoPlex4 PSU Blades
Figure 2-7. PSU blades.
Select the appropriate blade for use, place the top edge of the blade into the recess of the PSU and then slide upwards ensuring
the release catch clicks firmly into place and secures the blade inside the recess.
the release catch clicks firmly into place and secures the blade inside the recess.
To remove the blade, press the release catch down fully and pull the blade away from the PSU recess. The PSU is shipped fitted
with the UK blade.
with the UK blade.
2.4 Hardware Description
2.4.1 Front Panel
2.4.1 Front Panel
1
2
3
2
3
Figure 2-8. Front panel.
Table 2-1. Front-panel components.
Number Indicator
Description
1
(1) Power LED
Lights when the VideoPlex4 is connected to the power supply.
2
(1) Input LED
Lights when a valid DVI source is connected.
3
(1) Status LED
Lights steady on when the VideoPlex4 is operating normally.
Flashing when the unit is operating over the normal operating temperature. Make sure that the input fan vent is
not blocked.
not blocked.
Off when the settings configured in the VideoPlex4 application no longer match the input. This is normally the
result of a change of input. The VideoPlex4 will compensate for the settings and reconfigure itself to display as
near to the settings as possible. The output will still be displayed, but not necessarily as expected.
result of a change of input. The VideoPlex4 will compensate for the settings and reconfigure itself to display as
near to the settings as possible. The output will still be displayed, but not necessarily as expected.
Push to release blade