Black Box LEH906A-2SFP Manuel D’Utilisation

724-746-5500   |   blackbox.com 

Page 175

Chapter 7: Command-Line Management

7.12 LLDP

LLDP General Settings, LLDP Ports Settings, LLDP Neighbors, LLDP Statistics

LLDP:

1. Command Mode: Configure mode

Logon to Configure Mode (Configure Terminal Mode).

The switch_a(config)# prompt will show on the screen.

switch_a(config)#

2. Usage:

Use this command to enable Link Layer Discovery Protocol (LLDP) globally.

Use the no parameter with this command to disable Link Layer Discovery Protocol (LLDP) globally.

3. Command Syntax:

(no) lldp enable

4. Example:

The following example enables Link Layer Discovery Protocol (LLDP) globally:

switch_a(config)#lldp enable

switch_a(config)#

Holdtime Multiplier (2–10):

1. Command Mode: Configure mode

Logon to Configure Mode (Configure Terminal Mode).

The switch_a(config)# prompt will show on the screen.

switch_a(config)#

2. Usage:

Use this command to set the Link Layer Discovery Protocol (LLDP) holdtime multiplier value. The transmit interval is multiplied by 
the holdtime multiplier to give the Time To Live (TTL) that the switch advertises to the neighbors.

3. Command Syntax:

lldp holdtime multiplier <2-10>

<2–10> Holdtime multiplier 2-10, default is 4.

4. Example:

The following example sets Link Layer Discovery Protocol (LLDP) holdtime multiplier to 5:

switch_a(config)#lldp holdtime multiplier 5

switch_a(config)#

Tx Interval (5-32768 seconds):

1. Command Mode: Configure mode

Logon to Configure Mode (Configure Terminal Mode).

The switch_a(config)# prompt will show on the screen.