Tyan Computer B5103G12S2 Manuel D’Utilisation

http://www.TYAN.com 

  dev/em/if_em_hw.c optional em 
 
Remove the following lines from the /usr/src/sys/conf/files.i386 file if 
they exist: 
  dev/em/if_em_fxhw.c optional em 
  dev/em/if_em_phy.c optional em 
 
Edit the kernel configuration file (i.e., GENERIC or MYKERNEL) in /usr/src/ 
sys/i386/conf

 and ensure the following line is present: device em 

 
Compile and install the kernel, the system must be rebooted for the kernel updates to 
take effect. For additional information on compiling the kernel, consult the FreeBSD 
operating system documentation. 

6.  To assign an IP address to the interface, enter the following: ifconfig 

. 

7.  Verify that the interface works. Enter the following, where <IP_address> is the IP 

address for another machine on the same subnet as the interface that is being tested: 
ping <IP_address>

. 

8.  To configure the IP address to remain after rebooting, edit /etc/rc.conf and 

create the appropriate ifconfig_em<interface_num> entry: 
ifconfig_em<interface_num>=”<ifconfig_settings>”

 

Sample usage: ifconfig_em0=”inet 192.168.10.1 netmask 
255.255.255.0”

 

NOTE: For assistance, see the ifconfig main page. 

 

LCD Driver 

1.  Insert the driver CD into the CD drive. 

2.  Copy MiSM_FLCDxx.tar.gz of the /LCD/GS12/FreeBSD/ directory to the 

directory of your choice (where xx refers to the version). 

3.  Untar/unzip archive: tar xfvz MiSM_FLCDxx.tar.gz. 

4.  Change to the driver directory: cd MiSM_FLCDxx. 

5.  Install the WatchDog driver: make 

. 

6.  Restart your system.