DELL 1950 Manuel D’Utilisation
28
About Your System
No boot sector on hard
drive
Incorrect configuration settings in
System Setup program, or no operating
system on hard drive.
System Setup program, or no operating
system on hard drive.
Check the hard-drive configuration
settings in the System Setup program. See
"Using the System Setup Program" on
page 31. If necessary, install the operating
system on your hard drive. See your
operating system documentation.
settings in the System Setup program. See
"Using the System Setup Program" on
page 31. If necessary, install the operating
system on your hard drive. See your
operating system documentation.
No timer tick interrupt
Faulty system board.
Northbound merge error -
The following DIMM has
been disabled by BIOS:
DIMM x
The specified DIMM was unable to
establish a successful data link with the
memory controller.
establish a successful data link with the
memory controller.
PCIe Degraded Link Width
Error: Embedded
Bus#nn/Dev#nn/Funcn
Expected Link Width is n
Actual Link Width is n
Faulty or improperly installed PCIe
card in the specified slot.
card in the specified slot.
Reseat the PCIe card in the specified slot
number. See "Expansion-Card Riser" on
page 82. If the problem persists, see
"Getting Help" on page 125.
number. See "Expansion-Card Riser" on
page 82. If the problem persists, see
"Getting Help" on page 125.
PCIe Degraded Link Width
Error: Slot n
Expected Link Width is n
Actual Link Width is n
Faulty or improperly installed PCIe
card in the specified slot.
card in the specified slot.
Reseat the PCIe card in the specified slot
number. See "Expansion-Card Riser" on
page 82. If the problem persists, see
"Getting Help" on page 125.
number. See "Expansion-Card Riser" on
page 82. If the problem persists, see
"Getting Help" on page 125.
PCIe Training Error:
Embedded
Bus#nn/Dev#nn/Funcn
PCIe Training Error:
Slot n
Faulty or improperly installed PCIe
card in the specified slot.
card in the specified slot.
Reseat the PCIe card in the specified slot
number. See "Expansion-Card Riser" on
page 82. If the problem persists, see
"Getting Help" on page 125.
number. See "Expansion-Card Riser" on
page 82. If the problem persists, see
"Getting Help" on page 125.
PCI BIOS failed to install
PCI device BIOS (Option ROM)
checksum failure is detected during
shadowing.
checksum failure is detected during
shadowing.
Loose cables to expansion card(s);
faulty or improperly installed
expansion card(s).
faulty or improperly installed
expansion card(s).
Reseat the expansion card(s). Ensure that
all appropriate cables are securely
connected to the expansion card(s). If the
problem persists, see "Troubleshooting
Expansion Cards" on page 107.
all appropriate cables are securely
connected to the expansion card(s). If the
problem persists, see "Troubleshooting
Expansion Cards" on page 107.
Plug & Play Configuration
Error
Error encountered in initializing PCI
device; faulty system board.
device; faulty system board.
Install the NVRAM_CLR jumper and
reboot the system. See Figure 6-1 for
jumper location. If the problem persists,
see "Troubleshooting Expansion Cards"
on page 107.
reboot the system. See Figure 6-1 for
jumper location. If the problem persists,
see "Troubleshooting Expansion Cards"
on page 107.
Table 1-8.
System Messages (continued)
Message
Causes
Corrective Actions