DFI G586SP Manuel D’Utilisation
G586SP/G586SP AIO
28
PS/2 Mouse Port (optional): J3
The PS/2 mouse port is a 6-pin connector on the system
board. Attach the 6-pin mouse port cable to Connector J3
and make sure the brown wire on the PS/2 mouse connector
aligns with pin 1 of Connector J3.
board. Attach the 6-pin mouse port cable to Connector J3
and make sure the brown wire on the PS/2 mouse connector
aligns with pin 1 of Connector J3.
Parallel Port: J8
The system board has a standard connector for interfacing
your PC to a parallel printer. This port is compatible with
both IBM AT printer ports and the new, high speed, bidirec-
tional Extended Capabilities Port standard. The parallel port
on your system board can be set to any of the following
system I/O addresses: (1) 3BC-3BE Hex; (2) 378-37A Hex
(Default); (3) 278-27A Hex.
your PC to a parallel printer. This port is compatible with
both IBM AT printer ports and the new, high speed, bidirec-
tional Extended Capabilities Port standard. The parallel port
on your system board can be set to any of the following
system I/O addresses: (1) 3BC-3BE Hex; (2) 378-37A Hex
(Default); (3) 278-27A Hex.
Connecting the Parallel Printer Port
Attach the DB-25S printer port cable, which came with the
motherboard, to Connector J8. Make sure the colored stripe
on the ribbon cable aligns with pin 1 of Connector J8. Use a
small nutdriver to mount the cable into a DB-25 cutout in
the system chassis.
motherboard, to Connector J8. Make sure the colored stripe
on the ribbon cable aligns with pin 1 of Connector J8. Use a
small nutdriver to mount the cable into a DB-25 cutout in
the system chassis.
Floppy Disk Drive Controller
The system board has a built-in floppy disk controller that
supports two standard floppy disk drives. You can install any
720KB/1.2MB/1.44MB floppy disk drives.
supports two standard floppy disk drives. You can install any
720KB/1.2MB/1.44MB floppy disk drives.