Fujitsu D1241 Manuel D’Utilisation

3. HARDWARE SETUP

Layout Contents

1) DIMM 0/1/2/3 p.17 168-Pin System Memory Support
2) CPU p.19 Central Processing Unit (CPU)
3) PCI1/PCI2/PCI3/PCI4/PCI7 p.20 32-bit PCI Bus Expansion Slots (PCI7 depends on model)
4) PCI5/PCI6 p.20 64-/32-bit PCI Bus Expansion Slots (depending on model)

1) PS2KBMS p.22 PS/2 Mouse Connector (6-pin female)
2) PS2KBMS p.22 PS/2 Keyboard Connector (6-pin female)
3) USB p.23 Universal Serial Bus Ports 0 & 1 (Two 4-pin female)
4) LAN p.23 Fast-Ethernet Connector (RJ45)
5) PRINTER p.23 Parallel Port Connector (25-pin female)
6) COM1/COM2 p.23 Serial Port COM1/COM2 Connectosr (Two 9-pin male)
7) VGA p.24 Monitor (VGA) Output Connector (15-pin female)

  8) USBPORT p.24 Universal Serial Bus Port (10-1 pins)

9) CHASSIS p.25 Chassis Intrusion Connector (4-1 pins)

10) FLOPPY p.25 Floppy Disk Drive Connector (34-1 pins)
11) IDE1/IDE2 p.26 Primary/Secondary IDE Connectors (Two 40-1 pins)

12) WOL_CON p.27 Wake-On-LAN Connector (3 pins)
13) WOR p.27 Wake-On-Ring Connector (2 pins)
14) IDELED p.28 IDE/SCSI Activity LED (2 pins)
15) CPU_FAN1/2,CHA_FAN1/2 p.28 CPU and Chassis Fan Connectors (Four 3-pin)
16) SMB p.29 SMBus Connector (5-1 pins)
17) NIC (PANEL) p.29 NIC Activity LED (2 pins)
18) STATUS (PANEL) p.29 Status Activity LED (2 pins)

19) SMI (PANEL) p.29 System Management Interrupt Switch Lead (2 pins)
20) PWRSW (PANEL) p.30 ATX Power / Soft-Off Switch Lead (2 pins)
21) CHASSIS (PANEL) p.30 Chassis Intrusion Connector (2 pins)
22) RESET (PANEL) p.30 Reset Switch Lead (2 pins)
23) PWR.LED (PANEL) p.30 System Power LED Lead (3-1 pins)
24) NMI (PANEL) p.30 Non-Mask Interrupt Switch (2 pins)
25) SPEAKER (PANEL) p.30 System Warning Speaker Connector (4 pins)

26) IDELED (PANEL) p.30 IDE/SCSI Activity LED (2 pins)

27) ATXPWR p.31 ATX Power Supply Connector (20 pins)
28) SCSI-A/SCSI-B p.31 68-pin Ultra160/Ultra2 SCSI Connectors (Two 68 pins)