Fujitsu C122-E177-01EN Manuel D’Utilisation
MMB CLI (Command Line Interface) Operations
2.3.29 show ntpq
Displays the operating conditions of ntp.
Remarks
Support of IPv4, IPv6
Remarks
Support of IPv4, IPv6
Privilege: Aｌｌ
(1) Input format
show ntpq
(2) Option
None
(3) Usage example
# show ntpq
remote refid
None
(3) Usage example
# show ntpq
remote refid
st t
when
poll
reach
delay offset
jitter
=========================================================================
*10.23.4.3
*10.23.4.3
10.0.50.32
4 u
882
1024
377
0.941
-0.154 0.284
10.49.51.3
.INIT.
16 u
-
1024
0
0.000
0.000
0.000
LOCAL(0)
.LOCL.
5 l
23h
64
0
0.000
0.000
0.000
#
TABLE 2.8 Output Items of show ntpq
Item
Description
Symbols on the top of remote
Meanings of the symbols displayed on the top of a remote are listed below.
Blank: reject. It is not referred when request is not attained or the distance
is far (the period for to-fro communication to server is more than 16
seconds).
x:falsetick. The time, acquired from all other remote servers registered in
Blank: reject. It is not referred when request is not attained or the distance
is far (the period for to-fro communication to server is more than 16
seconds).
x:falsetick. The time, acquired from all other remote servers registered in
MMB, deviates (The value of jitter is deviated more than the allowance
range of deviation) as compared to the time acquired from more than
two remotes. Therefore, it was excluded from the reference list.
Falsetick cannot be detected when all the clocks are off.
range of deviation) as compared to the time acquired from more than
two remotes. Therefore, it was excluded from the reference list.
Falsetick cannot be detected when all the clocks are off.
-: outlyer. It is not referred because jitter value of this remote is greater than
offset of remote during the current synchronization
+: candidate. Can be synchronized any time.
#: selected. It is possible to synchronize but as the distance is far (the to-fro
#: selected. It is possible to synchronize but as the distance is far (the to-fro
communication period of the server is more than 1 second), it is
departed from candidate.
departed from candidate.
*: sys.peer. Synchronizing.
remote
Host name (“LOCAL” indicates MMB) referred as NTP Server (Server
providing internal clock to other computers trough ntp protocol).
providing internal clock to other computers trough ntp protocol).
refid
Indicates from where remote synchronizes the time. When it is not clear,
0.0.0.0.
0.0.0.0.
st
A number showing the level of server. Generally, as this number gets
larger, the reliability of time gets declined.
larger, the reliability of time gets declined.
t
Type of remote server
1: Local server. Acquisition of internal clock of MMB (This type is
1: Local server. Acquisition of internal clock of MMB (This type is
considered only when remote is LOCAL).
u: Unicast server. Executes time request for the remote from MMB and
acquires the transmitted time.
when
Elapsed time from the time when packet is received for the last time from
remote. (Unit: seconds).
remote. (Unit: seconds).
poll
Interval to acquire time from remote (Unit: seconds).
reach
Flag of failure and success of time acquisition of past 8 times. (Octal
numeral expression).
numeral expression).