Emerson ATCA-9305 Manuel D’Utilisation

 File Load Commands

ATCA-9305 User’s Manual

The file load commands load files over the serial port.

The loadb command loads a binary file over the serial port. The command takes two 
optional parameters:

The address offset parameter allows the file to be stored in a location different than what is 
indicated within the binary file by adding the value off to the file’s absolute address.

The baudrate parameter allows the file to be loaded at baud instead of the monitor’s con-
sole baudrate.

The file is not automatically executed, the loadb command only loads the file into memory.

loadb [off] [baud]

The loads command loads an S-Record file over the serial port. The command takes two 
optional parameters:

The address offset parameter allows the file to be stored in a location different than what is 
indicated within the S-Record file by adding the value off to the file’s absolute address.

The baudrate parameter allows the file to be loaded at baud instead of the monitor’s con-
sole baudrate.

The file is not automatically executed, the loads command only loads the file into memory.

loads [off] [baud]

The memory commands allow you to manipulate specific regions of memory. For some 
memory commands, the data size is determined by the following flags:

The flag .b is for data in 8-bit bytes.

The flag .w is for data in 16-bit words.

The flag .l is for data in 32-bit long words.

These flags are optional arguments and describe the objects on which the command oper-
ates. If you do not specify a flag, memory commands default to 32-bit long words. Numeric 
arguments are in hexadecimal.