Emerson ATCA-9305 Manuel D’Utilisation

 IPMC Commands

ATCA-9305 User’s Manual

The iprobe command probes to discover valid primary I

2

C bus chip addresses.

iprobe

IPMI Baseboard Management Controller (BMC) watchdog is supported and serviced 
throughout the monitor boot process. The BMC watchdog is disabled if the monitor goes to 
the monitor prompt.

The bootdev command gets or sets the initial boot bank. Get prints out the flash bank set as 
initial boot device.

bootdev get

The IPMC sets the hardware strapping for the initial boot device.

bootdev set <bank>

Where <bank> is either b0 or b1 for the corresponding flash bank, or b3 to boot from socket 
and if a shunt is installed on J9 [1:2].

The fru command opens, closes, saves, sets, shows, dumps, and loads fru data to and from 
the IPMC.

fru <command> [ arg1 arg2 … ]
command := [ open | close | save | set | show | dump | load | create ]
fru open <id>
fru close
fru save
fru set <section [chassis|board|product]><field><value>

fru set <section> <field> <value>
section := [ chassis | board | product ]

fru set chassis <field> <value>
field := [ type | part | serial ]

fru set board <field> <value>
field := [ date | maker | name | serial | part | file ]

fru set product <field> <value>
field := [ maker | name | part | version |serial | asset | file ]

fru show
fru dump <address>
fru load <address><size>

Set data in the internal use area.