Emerson ATCA-9305 Manuel D’Utilisation
Ethernet Interface:
MPC8548 Management Processor Ethernet
6-3
VLAN Setup
The default VLAN configuration is defined in
. See page 9-25 for the monitor vlan
command.
Table 6-2:
VLAN Configuration
MPC8548 MANAGEMENT PROCESSOR ETHERNET ADDRESS
The Ethernet address for your board is a unique identifier on a network. The address con-
sists of 48 bits (MAC [47:0]) divided into two equal parts. The upper 24 bits define a unique
identifier that has been assigned to Emerson Network Power, Embedded Computing by
IEEE. The lower 24 bits are defined by Emerson for identification of each of our products.
sists of 48 bits (MAC [47:0]) divided into two equal parts. The upper 24 bits define a unique
identifier that has been assigned to Emerson Network Power, Embedded Computing by
IEEE. The lower 24 bits are defined by Emerson for identification of each of our products.
The Ethernet address for the ATCA-9305 is a binary number referenced as 12 hexadecimal
digits separated into pairs, with each pair representing eight bits. The address assigned to
the ATCA-9305 has the following form:
digits separated into pairs, with each pair representing eight bits. The address assigned to
the ATCA-9305 has the following form:
3
SGMII 1 GB
Switch PHY to front panel RJ45 connector
4
SGMII 1 GB
Management processor PHYs to front panel RJ45 connector
5
XAUI 10 GB
Stratix II GX bridge 2
6
XAUI 10 GB
Stratix II GX bridge 1
7
XAUI 10 GB
Back plane Fabric
8
XAUI 10 GB
Back plane Fabric
9
—
not used
10
—
not used
11
XAUI 10 GB
BCM56802 to J30 to optional RTM
12
13
13
XAUI 10 GB
Stratix II GX bridge 3
14
XAUI 10 GB
Stratix II GX bridge 4
15
XAUI 10 GB
BCM56802 to J31 to optional RTM
16
17
18
17
18
VLAN:
Ports:
1
1, 3, 4
2
6, 7
3
8, 13
4
5, 11
5
12, 14
Port:
Interface:
Connection:
(continued)