Emerson ATCA-7350 Manuel D’Utilisation
4
ATCA-7350 Control via IPMI Programmer’s Reference (6806800H29E)
53
SOL Module Configuration
4.1
Introduction
This chapter includes the following sections:
z
Configure the SOL
z
Enable SOL load
z
Setup a SOL session
z
Query the configuration of SOL
z
Configure the SOL mode in OS
4.2
Configure the SOL
Before the configuration, the IPMC has no user or IP address, so you cannot connect to the
IPMC through IPMITOOL. In this case, you need to use IPMI commands through the IPMB
channel of the shelf managers to configure the SOL and set the IPMC.
IPMC through IPMITOOL. In this case, you need to use IPMI commands through the IPMB
channel of the shelf managers to configure the SOL and set the IPMC.
Configuring SOL
Perform the following six steps to configure the SOL:
1. Set the IP addresses of the two channels.
Use the command Set LAN Configuration Parameters of IPMI2.0 with Parameter
selector of 3.
See table 23-2 in section 23.1 of the IPMI 2.0 specification.
The value of Parameter selector is 3.
For example, on Emerson shelf manager, set the IP address of channel 1 to
172.17.10.78 and that of channel 2 to 172.18.10.78.
ipmicmd -k "0 90 0 0c 01 01 03 ac 11 0a 4e" smi 0
ipmicmd -k "0 90 0 0c 01 02 03 ac 12 0a 4e" smi 0
selector of 3.
See table 23-2 in section 23.1 of the IPMI 2.0 specification.
The value of Parameter selector is 3.
For example, on Emerson shelf manager, set the IP address of channel 1 to
172.17.10.78 and that of channel 2 to 172.18.10.78.
ipmicmd -k "0 90 0 0c 01 01 03 ac 11 0a 4e" smi 0
ipmicmd -k "0 90 0 0c 01 02 03 ac 12 0a 4e" smi 0
The IPMB address is the hardware address marked on the shelf multiplied by 2.