Epson S5U1C62000A Manuel D’Utilisation

  • For the first time this command is executed, no item can be skipped because no default value is set.

  • A multiple break will occur  when all the conditions for the PC, data RAM access, and register values

coincide.

  • The previously set PC break, data break and register break conditions are cleared by the bm com-

mand. Also, the multiple break setting is cleared when the bp, bd and/or br conditions are set after
the bm condition is set.

  • An error results if you input the item name other than one listed below, when using the direct input

mode.

Error : Incorrect identifier, use PC/ADDR/DATA/OPT/A/B/X/Y/F.

  • You can use the direct input mode to set multiple break condition at a time, or change one or several

items for multiple break setting.

  • In guidance mode, the following keyboard inputs have special meaning:

"q

↵

"

… Command is terminated. (finish inputting and start execution)

"^

↵

"

… Return to previous address.

"

↵

"

… Input is skipped. (keep current value)

When the command is terminated in the middle of guidance by "q

↵

", the contents that have been

input up to that time will be modified. However, these contents will not be modified if some cleared
settings are left intact.

When this menu item is selected, a dialog box appears for setting multi break conditions.

To set a multiple break, enter each condition in the
box and select a R/W condition from the radio
buttons, then click [OK]. All the conditions must be
set. Enter an "

∗

" to exclude the condition. If there is a

condition that has not been set (indicated with "---"),
no multiple break condition is set.
To clear the multiple break condition, click [Clear].