Emerson PMC-CGM Manuel D’Utilisation
PMC-CGM Installation and Use (6806800D53C)
Controls, LEDs and Connectors
BITS Interface Connectors
32
The Ethernet ports for the PMC-CGM are located on the ARTM-F103.
3.3.1
BITS Interface Connectors
The module provides two RJ-45 BITS front panel connectors.
Figure 3-2
Front Panel
Product Damage
The RJ-45 connector(s) on the face plate are BITS interfaces. Connecting a telephone
to such a connector may destroy your telephone as well as the product.
Make sure that BITS connectors near your working area are clearly marked as
network connectors. In addition, observe the following safety notes:
The RJ-45 connector(s) on the face plate are BITS interfaces. Connecting a telephone
to such a connector may destroy your telephone as well as the product.
Make sure that BITS connectors near your working area are clearly marked as
network connectors. In addition, observe the following safety notes:
z
Verify that the length of an electric cable connected to a BITS bushing does not
exceed 100 m.
exceed 100 m.
z
Make sure the BITS bushing of the system is connected only to
Telecommunication Network Voltage level 1 (TNV-1) circuits.
Telecommunication Network Voltage level 1 (TNV-1) circuits.
If in doubt, ask your system administrator.