Emerson 752I Manuel D’Utilisation

 Monitor Command Reference

Katana®752i User’s Manual

3

Update the monitor:
[Katana 752i (1.0)] => moninit serial# 100000 

4

Reset the monitor:
[Katana 752i (1.0)] => reset

5

Reset the environment parameters:
[Katana 752i (1.0)] => envinit serial# 

If moninit( ) fails, burn the new monitor to a ROM and follow the recovery steps in “Recov-
ering the Monitor” on page 15-7.

To reset the monitor’s environment variables, issue the following command, were serial# is 
the four digit serial number, 683-xxxx:

[Katana 752i (1.0)] => envinit serial# 

This section describes the syntax and typographic conventions for the Katana®752i moni-
tor commands. Subsequent sections in this chapter describe individual commands, which 
fall into the following categories: boot, memory, Flash, environment variables, test, and 
other commands.

The monitor uses the following basic command syntax:

• The command line accepts three different argument formats: string, numeric, and 

symbolic. All command arguments must be separated by spaces with the exception of 
argument flags, which are described below.

• Monitor commands that expect numeric arguments assume a hexadecimal base.

• All monitor commands are case sensitive.

• Some commands accept flag arguments. A flag argument is a single character that 

begins with a period (.). There is no white space between an argument flag and a 
command. For example, md.b 80000 is a valid monitor command, while md .b 80000 
is not.

• Some commands may be abbreviated by typing only the first few characters that 

uniquely identify the command. For example, you can type ver instead of version.