Acu-Rite CNC 3500i Manuel D’Utilisation

ACU-RITE 3500i

Control M-Codes execute or alter certain 3500i functions, such as 
program end, sub-program call, dry run, etc.

These M-Codes are part of the 3500i software. To use them, enter the 
appropriate M-Code into the program.

M0 or M00

Program Stop Mode. Program stops 
indefinitely. Touch Start to resume. 

M1 or M01

Optional Program Stop. Optional 
program stops indefinitely. Touch Start 
to resume. 

M2 or M02

End of Program. At M02, the program 
stops and returns to the first program 
block.

M19

Spindle Orientation. (Followed by the C 
word for a spindle orient to a specific 
angle [i.e., M19 C45 orients the spindle 
to 45 degrees].

M30

Jump to New Program. Return to other 
program. M30 O75 programmed, as the 
last block of a main program returns the 
3500i to program #75. O75 must be in 
the same file.

M98

Call sub-program. A block in the main 
program with M98 P100 executes 
sub-program 100. O100 must be in the 
file after the end of the main program.

M99

End of sub-program. M99 ends a 
sub-program and returns to the main 
program at the block preceding the last 
executed program call.

M105

Dry Run, All Axes. Program M105 in a 
program file or in MDI to set Dry Run 
Mode. 3500i executes all feed moves at 
a rate set by the builder. It enables you 
to run programs through quickly to check 
for mistakes. M107disables Dry Run.
NOTE: Making and saving a change to 
the Setup Utility cancels M105.