Q-Logic 8200 Manuel D’Utilisation

5–Fibre Channel Noninteractive Commands

Command Summary

SN0054667-00  C

5-5

This section lists and describes each command line option in alphabetic order, 
followed by a command description.

Use the -a command to either view (1) or change (2) the status of a beacon.

To view the adapter port’s LED beacon state, issue the following command:

# qaucli -pr fc -a (<hba instance> | <hba wwpn>)(view | info)

When the adapter’s LED is flashing, the following message appears:

HBA Port x - LED Flashing is ON.

When the adapter’s LED is not flashing, the following message appears:

HBA Port x - LED Flashing is OFF.

To start or stop flashing the adapter’s LED beacon, issue the following command:

# qaucli -pr fc -a (<hba instance> | <hba wwpn>)

QConvergeConsole CLI toggles the LED’s state. If the LED is flashing, the 
flashing stops. If the LED is not flashing, the flashing begins.

<target id> 

Target ID

<lun id> 

Logical unit number 

(0–255)

<address>

IP address

xxx.xxx.xxx.xxx

(speed)

Target link speed

1.2, 4, or 8GHz

a

You can use the -g command to find adapter numbers.

b

You assign the symbolic name. It is limited to 100 characters in length.



Adapter must not be in silent mode. See 

to issue a response to this command.



The -a feature is not supported on QLA22xx adapters or QLE8042 

adapter.