Q-Logic 8200 Manuel D’Utilisation

5–Fibre Channel Noninteractive Commands
-m (View, Enable, or Disable LUNs)

5-24

SN0054667-00  C

Use the -m command to:


View all selective LUNs for all adapter ports



View an adapter’s selective LUN list



View the current selective state of a LUN on a specific target



Enable (select) a LUN on a specific target on a specific adapter



Disable (deselect) a LUN on a specific target on a specific adapter



Enable all LUNs on a specific target on a specific adapter



Disable (deselect) all LUNs on a specific target on a specific adapter



Enable (select) all LUNs of all targets on a specific adapter



Disable (deselect) all LUNs of all targets on a specific adapter

For these commands:

To view all selective LUNs for all adapter ports, issue the following command:

# qaucli -pr fc -m all (view | info)

To view an adapter’s selective LUN list, issue the following command:

# qaucli -pr fc -m (<hba instance> | <hba wwpn> | all) (view | 
info)

QConvergeConsole CLI shows the adapter’s enabled LUN list in the following 
format:

<target wwnn> <target wwpn> <lun id> 



If the current driver setting is Bind by Port ID, this option is not available.



Under Linux, if you use the IOCTL or sysfs (inbox) driver, this feature is 
disabled.



You must persistently bind the targets before configuring selective LUNs, 
(link).

hba instance = Adapter number (use -g command to find)

hba wwpn = World wide port name of the adapter

target wwnn = World wide node name of the target
target wwpn = World wide port name of the target

lun id = ID of the LUN