Primera Technology 510212 Manuel D’Utilisation

30 Section 4:  Ribbon and Print Media

15. Once the Print Pressure Bracket is in the proper position, firmly push each

Securing Lever all the way down until each is in its locked position.  Some

force is required to latch these Securing Levers.

16. Reconnect the Sensor Connector by sliding it toward the right-hand side of the

printer until it stops.

17. To cut the excess paper you must run the Paper Load Sequence from the

Control Panel Menu. Press the Menu button until the display reads:

Next, press the Enter button. The press will engage it's Rotary Cutter, slicing off the

excess media to ensure a squared edge. The press will then position the paper

up into the print area.  Your press is now ready to receive a job.

If you would like to test the paper path and make sure that everything is loading

correctly, there is a paper-loading test in the press's menu. Press the Menu button

repeatedly until the LCD Display reads:

Press Enter to start the test. The press will draw paper in, reverse it, then feed it up

into the cutter. It will then sheet the paper with its Rotary Cutter and eject the

blank 12" x 20" sheet into the output tray.

Impressa3.qxd  10/22/01  9:29 PM  Page 30