Mocomtech CDM-570L Manuel D’Utilisation

CDM-570/570L Satellite Modem with Optional IP Module 

Revision 4 

Physical Description 

MN/CDM570L.IOM 

The IEC line input connector contains the ON/OFF switch for the unit. It is also fitted 
with two fuses, one each for line and neutral connections (or L1, L2, where appropriate). 
These are contained within the body of the connector, behind a small plastic flap. 
 

•  For 230 volt AC operation, use T2.5A, (slow-blow) 20mm fuses. 
•  For 115 volt AC operation, use T5.0A, (slow-blow) 20mm fuses. 

 

 

For continued operator safety, always replace the fuses with the correct type and rating. 

CDM-570L: The IF port connectors are both a 50

Ω ‘N’ female type. The return loss on 

these ports is greater than 19 dB (typically better than 21 dB), and if the user wishes to 
connect to a 75

Ω system, an inexpensive ‘N’ to ‘F’ type adapter can be used. While there 

will be a reduction in return loss when doing this, the effect in most systems will be 
imperceptible. 
 
CDM-570: The IF port connectors are both a BNC female type. The return loss on these 
ports is greater than 17 dB (typically better than 19 dB) in BOTH 50

Ω  and 75Ω systems. 

The Data connector is a 25-pin ‘D’ type female (DB25-F). This connector conforms to 
the EIA-530 pinout, which allows for connection of different electrical standards, 
including EIA-422, V.35, and EIA-232. A shielded 25-pin ‘D’ type provides a very solid 
solution to EMC problems, unlike the sometimes used V.35 Winchester connector.  
 

 

It is the responsibility of the user to provide the appropriate cables to connect to 
this EIA-530 connector. 

 

 

4–3