Mocomtech CDM-570L Manuel D’Utilisation

Page de 452
CDM-570/570L Satellite Modem with Optional IP Module 
Revision 4 
Typical IP Module Operation Setups 
MN/CDM570L.IOM 
16.3 
IP Module Working Modes 
Two Working Modes of the IP Module are available: easyConnect
™ and Router Mode. 
There are also three HDLC Addressing Modes: Point-to-Point, Small Network, and Large 
Network. Separate HDLC Modes allows the user to minimize the HDLC overhead 
transmitted over the satellite based upon the size of their network. In Router/Point-to-
Point Mode, no HDLC address is transmitted; Router/Small Network transmits 1 byte 
and Router/Large Network transmits 2 bytes as part of HDLC header for each packet. 
Non-IP traffic is not supported in Router Mode. 
This section describes the functionality of these modes in order to optimize the  
Comtech EF Data IP modems in the network, based upon Network Topology and 
Ethernet Traffic requirements. 
 
IMPORTANT
 
The Working Mode and HDLC Address Mode of the Comtech EF Data IP modems 
must be identical to pass traffic between modems.  
Changing the Working Mode or HDLC address Mode of the IP modem requires the IP 
Module to be rebooted. Before the user can select a different mode, the IP Module 
will notify the user that changing the mode will require a reboot.    
 
 
Working Mode 
HDLC Address Mode 
Network Topology 
Ethernet Traffic 
easyConnect
 Mode 
Point-to-Point 
Point-to-Point only 
Both sites on same LAN subnet 
IP v4 and/or non-IP 
Router Mode 
Point-to-Point 
Point-to-Point only 
Both sites on different LAN subnet 
IP v4 only 
Router Mode 
Small Network 
Point-to-Point or Point-to-Multipoint 
(up to 254 sites) 
All sites on different LAN subnet 
IP v4 only 
Router Mode 
Large Network 
Point-to-Point or Point-to-Multipoint 
(up to 32766 sites) 
All sites on different LAN subnet 
IP v4 only 
 
 
16–2