Mocomtech CDM-570L Manuel D’Utilisation

CDM-570/570L Satellite Modem with Optional IP Module 

Revision 4 

IP Module - CLI and Telnet Operation 

MN/CDM570L.IOM 

The Working Mode page is activated from the Administration page. 

 

Changing the Working Mode will require a system reboot. 

 
The Working Mode contains the following option/field: 
 

IP M

odule Working Mode 

Select the Working mode:  

For all Router Modes - IP packets are routed based on 
the Route table information input by the user. Non-IP 
packets are discarded. Operates at 10/100BaseT. 

 

Router – Small Network: Router uses 1 byte hdlc 
addresses. 

Router – Large Network: Router mode using 2 byte 
hdlc addresses. 

Router – Point to Point: Router mode uses 0 hdlc 
addresses to save satellite bandwidth 

Router – Vipersat: Router mode when running in a 
Vipersat Network. 

EasyConnect: default operating mode, and operates at 
10/100BaseT. In this mode the 

IP M

odule will forward 

both IP and non-IP datagrams over satellite without 
any defined routes.  

See Chapter 15 for additional information. 

 
 

17–18