Trendnet TEW-638PAP Manuel D’Utilisation

Page de 65
Federal Communication Commission Interference Statement 
This  equipment  has  been  tested  and  found  to  comply  with  the  limits  for  a  Class  B  digital 
device,  pursuant  to  Part  15  of  the  FCC  Rules.    These  limits  are  designed  to  provide 
reasonable protection against harmful interference in a residential installation. This equipment 
generates  uses  and  can  radiate  radio  frequency  energy  and,  if  not  installed  and  used  in 
accordance  with  the  instructions,  may  cause  harmful  interference  to  radio  communications.   
However, there is no guarantee that interference will not occur in a particular installation.    If 
this equipment does cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one of the following measures: 
  Reorient or relocate the receiving antenna. 
  Increase the separation between the equipment and receiver. 
  Connect the equipment into an outlet on a circuit different from that to which the receiver 
is connected. 
  Consult the dealer or an experienced radio/TV technician for help. 
 
FCC Caution: Any changes or modifications not expressly approved by the party responsible 
for compliance could void the user's authority to operate this equipment. 
 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions:  (1)  This  device  may  not  cause  harmful  interference,  and  (2)  this  device  must 
accept any interference received, including interference that may cause undesired operation. 
 
IMPORTANT NOTE: 
FCC Radiation Exposure Statement: 
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled 
environment. This equipment should be installed and operated with minimum distance 
20cm between the radiator & your body. 
 
This transmitter must not be co-located or operating in conjunction with any other antenna or 
transmitter. 
 
The  availability  of  some  specific  channels  and/or  operational  frequency  bands  are  country 
dependent  and  are  firmware  programmed  at  the  factory  to  match  the  intended  destination. 
The firmware setting is not accessible by the end user.